The Uni-Verb is a painstakingly accurate photocell analog vibe based on of the original Univibe pedal with an added spring reverb.
It is always best to have the Uni-Verb effect first in the chain and Reverb last in the chain so we have built in a loop to allow you to do so.
Replacing the rocker switch to select either vibe or chorus on the original, a footswitch was added to toggle on the fly
The classic version of this pedal ran at 24v using a fixed power cable. We have designed the Uni-Verb to run off of a standard (Negative tip) 9v feed but utilizing a charge pump internally to bump it up to 24v. This way you can use your standard 9v input with no worries at all, no special cables or power supplies.
Specs & Features
Controls
Inputs & Outputs
Size & Power
Controls
Reverb: Controls the intensity of the Reverb
Dwell: Controls the length of the Reverb
Intensity: Controls the intensity of the Chorus and Vibe “Turnaround”
Output: Controls the output level
Chorus/Mix: Blends the dry signal with the wet signal on chorus only
Speed: Controls the speed of the vibe and chorus
Inputs & Outputs
Input
Output
Effect Loop Send
Effect Loop Return
Size & Power
4.75″X5.25″X1.25 (2.25″ to top of knob”)
2 lbs
9V/DC NEGATIVE TIP ONLY! No Battery available
DO NOT TRY TO POWER THE UNI-VERB WITH 24v OR ANYTHING OTHER THAN A NEGATIVE TIP OR 5.5/2.1mm 9v TYPICAL SUPPLY. If you power it with anything other than that it WILL damage the pedal and void your warranty.